Hi
in the NCM administration guide there's an example "Change VLAN Membership on ports Cisco IOS" which I seem to have understood.
Question:
what if I wanted to use this example and at the same time change the interface description for 2 interfaces (of course each interface gets a different description).
What if I selected more than 2 interfaces? How would it work then?
In my opinion there should be an input box for each interfaces description which pops up, after I've selected the interfaces I want to change.
At the moment I don't see how I can do this, but perhaps I'm just stupid. Could someone enlighten me?
It's not really useful if I have to call the same config change template over and over again if I'm only able to change one interface at a time.
thanks for any helpful comments
Beat