My situation is that I have some 30 remote locations and when a switch or router goes bad, I have to configure a replacement and then usually take it to the remote location and install it. Currently, the method I use is to bring up the configuration in NCM and then have to cut and paste the configuration to the new device.
If I am replacing a working device, I can tftp the config off of the old device and then tftp the config onto the new device which is much easier (I simply put the new device on the network, assign a temporary IP address to that interface and can get the new device totally ready very quickly.
Cut and paste works but I would think it much nicer to be able to do something similar to the tftp suing the configs I am storing in NCM.